Brand New - AutoLabel Compatible Printheads

We represent the last American Manufacturer of Printheads. Yes, even Axiohm is manufacturing their printheads overseas. Our American Made, Compatible Axiohm Printhead will outlast an original AutoLabel Printhead at a fraction of the price. We believe in providing a quality product, providing a cost savings to our clients, and saving American Jobs

Our Thermal Printhead vs the AutoLabel PI-4000 thermal transfer Imprinter - 203 DPI Printhead

• Abrasive life of 100 kilometers for our printhead. Abrasive life of an Avery Berkel Printhead may only be 10 kilometers.

• Thermal life of 100 million pulses for our printhead. Stated pulse life of an Avery Berkel print head is 50 million pulses.

• Independent lab testing showed the resistance in our thermal printhead will began to change after 330,000 inches. An Autolabel Printhead tested in identical lab conditions showed  resistance change at 30,000 inches.

• Our printhead is built for a 100% dot duty cycle. Avery Berkel AutoLabel PI-4000 thermal transfer Imprinter - 203 DPI Printhead stated duty cycle is 90%. Our printhead duty cycle provides you with the highest clarity, print accuracy, and reproduction available in a printhead.

• Dot density up to 203 dpi (12 dpmm)
  

• Print speed up to 12 inches (305mm) per second
  
• Resistor line location (edge, near edge, etc.) Allows you to print at the edge of your media.
  
• Direct thermal or thermal transfer printhead.

How do we achieve these results?

• Our Printhead is built using a protective diamond like carbon (DLC) coating and is specifically desgined for Avery Berkel Part Number SDP-104-832-AM2. Our Diamond like coating provides a surface hardness equivalent to Rockwell 85 to 90. The Diamond like coating will protect the printhead when used in bar coding, ticket printing, thermal printing, printing against ribbons, and printing using other abrasive media. The Avery Berkel printhead does not use a protective coating.

• Our Thermal Print head uses Thick film technology. The Avery Berkel Printhead will use Thin Film. Thick Film printheads use gold, insulating and resistive pastes which are screen printed onto a ceramic substrate. AutoLabel PI-4000 thermal transfer Imprinter - 203 DPI Printhead will use a pressure contact between the printed circuit board and ceramic substrate. The thick film technology allows for a reduction in resistance versus pressure contact technology. As a thermal printhead wears the value of resistance changes. A 15% change in the value of resistance results in a printhead unable to function and print the required dot density.  

• Our thermal printhead will use Gold wire bond between the printed circuit board and ceramic substrate. We believe the gold wire bond provides for greater signal integrity and a longer life of the printhead. An AutoLabel thermal printhead will just use pressure contact and eliminate the gold wire bond. Gold is an expensive conductor we believe works best in an abrasive print head environment.

• Our thermal print head uses a hard black epoxy and silicon glass clear coating to protect the gold wire bonds and sensitive electronic circuitry against moisture and harsh environments. The AutoLabel thermal printhead will use pressure contact without a coating.

• Our thermal printhead incorporates the use of positive temperature coefficient (PTC) and negative temperature coefficient (NTC) thermistors for regulating temperature in the printhead. The PTC thermistor is used to quickly bring the printhead up to operating temperature, increasing your first time print cycle, and conserving energy. The NTC thermistor is used to regulate the heat output which conserves energy and prolongs the life of the printhead. Typically, the Avery Berkel printhead will not use the NTC and PTC thermistors. This combination thermometer and resistor device is expensive.

• Our printhead will use Dot history control (DHC) for consistent print quality at high speed