 | |
100, Intermec 3000a Printheads, 200 DPI
This Printhead is for Intermec 3000a Product Number: 48790 and works in the Intermec 3000A Printer. Our Printheads feature a hard protective coating that extends the abrasive life of our printheads by up to four times that of our OEM competition. Our Warranty meets or exceeds all OEM Printhead Manufacturers. Our New OEM compatible thermal printheads are available for shipment worldwide. These are brand new printheads, not rebuilts not remanufactured - BRAND New and built in the USA. Minimum order quantity is 100 printheads. Item is priced at minimum quantity.
|
Our Printheads Feature a Diverse array of Characteristics.
• Dot density up to 300 dpi (12 dpmm)
• Print speed up to 12 inches (305mm) per second
• Resistor line location (edge, near edge, etc.)
• Direct thermal or thermal transfer
• PTC for preheating
• NTC for overheating protection
• Dot history control (DHC) for consistent print
quality at high speed
• DLC coating for extended wear life
• Thick Film or Thin Film technology
• Unequaled abrasive life of 100 kilometers is
up to four times as long as the rated wear life
of our largest OEM competitors.
• Unequaled thermal life of 100 million pulses,
once again twice the stated pulse life of our
largest competitors.
• "One hundred percent dot duty cycle." Provides
the user with the capability of addressing all
elements for the highest clarity, print
accuracy, and reproduction.
• Gold wire bonds versus pressure contact
between printed circuit board and substrate for
greater signal integrity.
• Hard black epoxy and/or silicon clear coating
protects gold wire bonds and sensitive
electronic circuitry against moisture and harsh
environments.
|
Ganson Engineering, Inc., 2901 W. Clarendon , Phoenix, AZ 85017
Tel 602-264-0288, Fax 602-277-5181
|
Refer a new customer to us and after they place their
first order, we will reward you with a 5% discount on your next purchase!
|
|
|
|
|
|
|